Category Archives: FAQ

This question was asked by
– Mr David S Hobday

Can this heater be hung vertically and could it be but directly below a socket

Good Afternoon,

Thank you for your message.

We would advise against mounting vertically solely because the heat is dissipated from the top of the unit and by being vertically mounted the heat wouldn’t fill the area and heat the space.

There aren’t any issues with the controls or internals of the heater but it would dramatically reduce the efficiency of heating the space.

I hope this helps.

Kind regards,

Lewis

Lewis Dowson

This question was asked by
– John taggart

Do these fit dexion p90?

Good Afternoon,

Please could you send some images of your uprights to [email protected] and from there we shall advise which locking pins you need for the system you have.

Kind regards,

Lewis Dowson

This question was asked by
– Mr David S Hobday

What are the costs per hour to run

Good Afternoon,

Thank you for your message.

As an average yearly cost to run the Ecopanels2000 at 12 hours every day, the cost would be approximately £306.63 with an average usage of 3,407Kw per year.

If you require more information on the cost to run this unit, please let me know as I have a document which explains this further.

Kind regards,

Lewis Dowson

This question was asked by
– andrew cridland

when installing these heaters the cable length is 1.5 can the cable run behind the heater to reach the left or right mains socket to plugin with 13 amp plug depending on which side the cable is fixed to the heater.

Good Morning,

Thank you for your message.

What we would recommend is you take the cable feed this approx. 4 inch down and then run across. This is to give a clear spacing for airflow and to avoid the cable overheating against the element which is based at the bottom of the heater or the pressed steel which the Radiator is made from.

Kind regards,

Lewis Dowson

This question was asked by
– David P

Where is the dual wattage switch on this dryer because we may need to change it depending on the season

Good Morning,

Thank you for your message.

The hand dryer has a built-in sensor beneath that monitors the ambient temperature and then deciphers which intensity (wattage) is applicable. However, in the standard Tempesta model, there is a dip switch inside the unit which allows you to alter the out out.

I hope this helps.

Kind regards,

Lewis Dowson